Testing The Router's Vadb Components; Figure 36: Verifying The Vadb Configuration - Hughes HN9500 Installation Manual

VADB feature setup and testing

Testing the router's VADB components

Figure 36: Verifying the VADB configuration

3. Check the response code below VADB Client Status Result:
• If the response code reads Vadb Client Status Request Executed, the satellite router
is configured for VADB and you can proceed with VADB setup.
• If the response code reads Vadb Client Status Request Not Executed Because
VADB is Not Supported, the router is not configured for VADB. Contact Installer
Support.
Before connecting the satellite router's phone line port to the phone line, test the router's VADB
components and circuitry.
1. On the installer laptop, launch a web browser and go to the Advanced Pages.
If you do not know how to go to the Advanced Pages, see
page 104.
2. In the Advanced Menu (in the left panel of the Advanced Configuration and Statistics screen),
click Vadb → VADB Modem Loopback Test.
3. Click to select VADB Modem Loopback Analog Test from the four listed tests.
Accessing the Advanced Pages
HN9500 Satellite Router Installation Guide
1037736-0001 Revision G
Chapter 8
on
59