Table of Contents
Advertisement
Validating the installation
Accessing the OVT
• Commissioning and registration must be complete, as indicated by state code 25, which
means the router is fully operational.
• To access the OVT software, you must:
• Be able to log into the Installation Portal. This requires a registered user name (Installer
ID) and password.
If you are not registered, contact your dealer or distributor to create an account and
obtain an Installer ID and password.
• Know the site SAN and FSO numbers. These numbers appear on the Installation
Reference Sheet.
Note: SAN refers to the site account number or master account number. FSO
refers to the field service order number.
If the installer laptop is configured for a link-local IP address, you will not be able to access the
OVT unless you remove the link-local address or configure 192.168.0.2 as an additional private
IP address. Make sure DHCP is enabled on the laptop unless you use the 192.168.0.2 private
address option. For detailed address configuration information, see
laptop IP address
on page 107.
If for any reason you cannot access or use the OVT, call Hughes Installer Support.
To access and start the OVT:
1. Make sure your laptop computer is connected to the router's LAN port.
2. After commissioning and registration have completed, type www.systemcontrolcenter.com
or 192.168.0.1 into the browser address bar, then press Enter.
The System Control Center home page appears, as shown in
System Control Center page
on page 44, displaying an Activate link and a Validate link.
HN9500 Satellite Router Installation Guide
1037736-0001 Revision G
Chapter 6
Configuring the installer
Figure 23: Validate link on
43
Advertisement
Table of Contents
Troubleshooting
