Table of Contents
Advertisement
Appendix
B
Standards compliance
Category
Telecommunications standards
Electromagnetic Interference (EMI) standards
Safety standards
Telecommunications standards
FCC Part 68
The HN9500 satellite router has been certified to conform to the standards shown in
HN9500 standards compliance
Table 20: HN9500 standards compliance
Certain rules concerning telecommunications apply to the HN9500 satellite router. These rules
concern ringer equivalence, discontinuance of service, repairs, and other matters. These rules
apply to the HN9500 router because it has an internal telephone modem and a phone connector
to support VADB.
Standards to which Conformity is declared: FCC Part 68
Part 68 Compliance – This equipment (two-way Hughes system: Model Number: HN9500)
complies with Part 68 of the FCC rules and requirements adopted by the ACTA. On the rear
panel of this equipment is a label that contains, among other information, the product part number
(P/N) in the format XXXXXXX-XXXX and an eight-digit Electronic Serial Number (ESN). If
requested, this information must be provided to the Telephone Company.
The two-way Hughes system must be installed according to the instructions in the installation
guide. Coaxial cables (Rx and Tx) must be grounded at the point of entry. A plug and jack used
to connect this equipment to the premises wiring and telephone network must comply with the
applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant 26 Gauge
telephone cord and modular plug is provided with this product. It is required to be terminated
with a plug type 605 or a FCC plug type 6 position for Australia.
on page 111. Additional information follows the table.
Standard
FCC Part 68 for the United States
CS-03 standard for Canada
FCC Part 15 for the United States
ICES-003 for Canada
UL60950-1 for the United States
CAN/CSA-C22.2 No. 60950-1 for Canada
HN9500 Satellite Router Installation Guide
Table 20:
1037736-0001 Revision G
111
Advertisement
Table of Contents
Troubleshooting
