Datasat RS20i Installation And Operating Manual page 90

Table 32. USB Flash Drive Options
Option
Save on USB
Load from USB
RS20i Installation & Operating Guide
RS20i Installation and Operating Guide
Result
Save RS20i Configuration. This will erase any previous RS20i Configuration
file from this unit on the USB device. The RS20i Configuration file is given the
name rs20_nnnn.tgz, where nnnn is the RS20i serial number.
Save MasterConfiguration. The MASTER configuration may be loaded onto
other RS20i units. This will erase any existing RS20i Master Configuration file
on the USB device. The Master Configuration file is given the name
rs20_MASTER.tgz.
Save Diagnostic Information to the USB device to facilitate troubleshooting.
The RS20i Diagnostic file is given the name DIAG_nnnn.tgz, where nnnn is the
RS20i serial number.
Copy RS20i Configuration from USB device to system. The RS20i
Configuration file is identified by the name rs20_nnnn.tgz, where nnnn is the
RS20i serial number. This will ERASE the existing configuration on the RS20i
and cause a system restart after loading the new configuration.
Copy RS20i Master Configuration from USB device to system. The RS20i
Master Configuration file is named rs20_MASTER.tgz. This will ERASE the
existing configuration and cause a system restart after loading the new
configuration.
Load a ScreenSaver graphic image (rs20.jpg) from the USB device. The
screensaver must be a jpeg image. The maximum image size is a 800 wide x
480 high (smaller images will be centered). The file must be named "rs20.jpg"
and placed in the root directory of the USB device.
Page 90
Document # 9301H52900 Ver. 1.02