Configuration Using 1 Or More Subwoofers - Datasat RS20i Installation And Operating Manual

Select the subwoofer configuration with the appropriate number and position of the subwoofers used.
The channel assignments for the selected subwoofer configuration are listed on the screen when
selecting one or more subwoofers.
Skip to page 81 to setup bass management for a configuration with no subwoofers.
4.7.1

Configuration using 1 or more subwoofers

Select Full-Range to Subs only if you wish to omit the Low Pass filter for all channels crossed to the
subwoofer.
For steps 2 through 10, tap on the speaker below its label and set the options for that speaker. Skip any
speakers that do not apply to the current speaker configuration. Use the Back button to return to the main
Bass Management screen to select the next speaker. Those speakers that are not used will be grayed
out and cannot be selected.
C – Center speaker Options:
Large – (default) Speaker can handle full range of frequencies.
Small – Cross with the subwoofer(s). Select the desired crossover filter frequency and slope. The
high-pass filter to the Center speaker may be disabled if desired.
Low Pass to Left/Right – Cross the center channel to the Left and Right Front speakers. Adjust
the crossover frequency and slope as needed.
Phantom Center – Use this if there is no center speaker installed. This divides the center
channel between the left and right speakers. The offset can be adjusted. Note: when this is
selected, the speaker is grayed out on the main Bass Management screen.
L, R – Left and Right speaker options:
Large – (default) Speaker can handle full range of frequencies.
Small – Cross with the subwoofer(s). Select the desired crossover filter frequency and slope. The
high-pass filter to the Left and Right speaker may be disabled if desired.
Ls, Rs – Left Surround and Right Surround speaker options:
Large – (default) Speaker can handle full range of frequencies.
Small – Cross with the subwoofer(s). Select the desired crossover filter frequency and slope.
Small, cross to L/R – The Left Surround will be crossed to the Left Front speaker and Right
Surround will be crossed to the Right Front speaker. Select the desired crossover filter frequency
and slope. In order to use this option, the Left and Right Front speakers should be defined as
Large. If not, an error message will appear on the screen.
Phantom Surround – Use this if Left and Right Surround speakers are not installed. The Left
Surround channel is mixed with the Left Front speaker and the Right Surround channel is mixed
with the Right Front speaker. The offset can be adjusted.
Lb, Rb – Left Back and Right Back speaker options:
Large – (default) Speaker can handle full range of frequencies.
Small – Cross with the subwoofer(s). Select the desired crossover filter frequency and slope.
Small, cross to L/R – The Left Back will be crossed to the Left Front speaker and Right Back will
be crossed to the Right Front speaker. Select the desired crossover filter frequency and slope. In
order to use this option, the Left and Right Front speakers should be defined as Large. If not, an
error message will appear on the screen.
Lw, Rw – Left Wide and Right Wide speaker options:
Large – (default) Speaker can handle full range of frequencies.
Small – Cross with the subwoofer(s). Select the desired crossover filter frequency and slope.
HL, HR – High Left and High Right speaker options:
Large – (default) Speaker can handle full range of frequencies.
RS20i Installation & Operating Guide
RS20i Installation and Operating Guide
Page 80
Document # 9301H52900 Ver. 1.02