Datasat RS20i Installation And Operating Manual page 139

Control Commands
3. Standby Power
Command:
Response:
This is used to control the power mode.
Note: On a network TCP/IP connection, the network connection is closed / reset during
the power on process. A reconnection should be performed after power on.
Parameters
Mode
0
1
Example
Set unit to operating mode.
Send:
Receive:
4. Screensaver On/Off
Command:
Response:
This is used to display the screen if the screensaver is active, or to activate the
screensaver. This command works only when the screensaver mode is enabled in the
system setup.
Parameters
Cmd
ON
OFF
Example
Activate the screensaver:
Send:
Receive:
Appendix E. Remote Command API
RS20i Installation and Operating Guide
@POWER<space>[mode]<CR>
POWER<space>mode<CR>
Selection
Power off, or sleep mode
O
perating mode. Requires 15 seconds for unit to be
operational
@POWER 1<cr>
POWER 1<cr>
@SCR<space>[Cmd]<CR>
OK<CR>
Selection
Deactivate the screensaver
Display the screensaver
@SCR OFF<cr>
OK<cr>
Operation
Read/Write
Operation
Document #: 9301H52900 Ver. 1.02
Page E-4
Write