Ip Port Settings - Panasonic KX-NT400 Operating Instructions Manual

Installation and Setup
Note
The IP addresses of PBXs cannot be obtained from
the DHCP server. You must manually enter the PBX
IP addresses.
PBX IP Address 1
Enter the IP address of the primary PBX. Press
Test to verify the connection to the PBX.
PBX IP Address 2
If your network uses a secondary PBX, enter the IP
address of the secondary PBX. Press Test to verify
the connection to the PBX.
PBX Change Time
If your network uses a secondary PBX, enter the
length of the time before the failover process starts.
•
Default: 60 seconds
Note
•
You can confirm the connection to the
secondary PBX after programming. When the
KX-NT400 is starting up, press and hold both
(HOLD) and
starting ..." appears.
To reconnect to the primary PBX, restart the
KX-NT400. For details, see "Restarting the
KX-NT400 (Page 176)".
•
You can also use the dial keys to enter the IP
addresses. See "Entering Characters
(Page 155)".
•
You can reset the settings to their default values
by pressing Reset to Default.
168 Operating Instructions
until the message "Now

IP Port Settings

To properly connect the KX-NT400 to a network, the IP
port settings must be configured to match the settings
of the network. Consult your administrator for details
about the correct settings.
If your network uses a secondary PBX, also fill in the
following for IP Port 2:
•
PTAP Server
•
PTAP Client
Note
•
These settings should be configured only by an
administrator or installation personnel. An
access code is required to access these
screens.
IP Port Setting screen (1/2)
Enter the IP ports of the PTAP server and PTAP client
for IP Port 1 that the KX-NT400 will use to communicate
over the network.
PTAP Server
Enter the port number for the PTAP server.
•
Default: 9300
PTAP Client
Enter the port number for the KX-NT400 to use for
PTAP communication.
•
Default: 9301
IP Port Setting screen (2/2)
If your network uses a secondary PBX, enter the IP
ports of the PTAP server and PTAP client for IP Port