Panasonic KX-NT400 Operating Instructions Manual page 166

Installation and Setup
Start-up menu
From the menu on the Setup screen, you can access
the following settings screens to configure the start-up
settings:
1.
Language (® Page 167)
If your prefer to use a language other than English,
change your language settings first.
2.
IP Address (® Page 167)
You must configure the IP address settings in order
to connect to the network and use the KX-NT400.
3.
IP Port (® Page 168)
If your network uses different ports than the default
settings, change these settings to match those of
your network. For a list of defaults, see "Network—
IP Port (Page 185)".
4.
QoS (® Page 169)
If your network uses QoS (Quality of Service) for
voice communication, configure these settings to
match those of your network.
5.
Maintenance (® Page 170)
View the MAC addresses for the KX-NT400's
network adaptors, and test connections to other
network devices.
6.
Firmware Version Update (® Page 171)
If a new firmware version is released, perform a
firmware upgrade to install the latest version.
For details about firmware, consult your dealer.
7.
Initialise Settings (® Page 173)
Initialising the settings resets the KX-NT400 to its
factory shipment state. Performing this operation
erases all data (contact lists, camera settings, etc.).
8.
Firmware Version (® Page 173)
View the installed version of various firmware
components.
9.
Error Log (® Page 174)
View system error messages.
Exiting the start-up settings
1.
Press Close on the Setup screen.
166 Operating Instructions
Note
•
When you change certain settings, the
KX-NT400 restarts automatically after you
press Close on the Setup screen.
For details, see "Restarting the KX-NT400
(Page 176)".