Bluetooth Headset Connections; Installation - Panasonic KX-NT400 Operating Instructions Manual

Bluetooth Headset Connections

Installation

CAUTION
Before touching the KX-NT307 Bluetooth module, discharge static electricity by touching ground.
Otherwise, this module may malfunction due to the static electricity.
Installing the KX-NT307 Bluetooth Module
1.
Disconnect the Ethernet cable (and AC adaptor if used) and make sure that the power is off.
2.
Remove the screw as shown in the illustration below.
3.
Remove the cover as shown in the illustration below.
Notice
•
To prevent the KX-NT400 from getting scratched, do not use hard, sharp tools (flat drivers, craft
knives, etc.) to open the cover.
4.
Install the KX-NT307 Bluetooth module to the Bluetooth module socket (see "Location of Controls
(Page 19)").
5.
Re-attach the cover.
Installation and Setup
Operating Instructions 161