4.3.2 Ethernet Port Settings
Phone User Interface
Reference
Configuration File Reference
DNS2
Description
Value Range
Default Value
Phone User Interface
Reference
Configuration File Reference
4.3.2 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
•
When you change the settings on this screen and click [Save], after the message "Complete" has been
displayed, the unit will restart automatically with the new settings applied. If a unit is on a call when
"Complete" has been displayed, the unit will restart after the unit returns to idle.
•
Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings or perform IP
Reset through phone user interface programming. For details, refer to the Operating Instructions on
the Panasonic Web site (® see Introduction).
80
Administrator Guide
Configuring the Network Settings of the Unit (Page 19)
USER_DNS1_ADDR (Page 190)
Specifies the IP address of the secondary DNS server.
Note
•
This setting is available only when [Connection Mode] is set
to [Static].
Max. 15 characters ("n.n.n.n" [n=0–255], except "0.0.0.0",
"255.255.255.255", "127.0.0.1", etc.)
Not stored.
Configuring the Network Settings of the Unit (Page 19)
USER_DNS2_ADDR (Page 190)
Document Version
2012-02