Language Settings; Ip Address Settings - Panasonic KX-NT400 Operating Instructions Manual

Language Settings

The Language settings allow you to select the display
language.
You can select from a list of built-in languages, or, if you
have an SD memory card with additional language files,
you can select one of those languages.
Language Setting screen
Select the display language.
Language
Select Language and then press the drop-down list
to select the display language from a list of built-in
languages.
•
Default: English-US
•
Built-in languages: English-US, English-UK,
French, French-CA, German, Spanish, Italian,
Portuguese, Russian, Ukrainian
Another
Select Another and then press
display language from an SD memory card.
Language files must be stored in the following
directory on the SD memory card:
\private\meigroup\pcc\pbxpt\nt400
Notice
•
If you have modified any of the preset presence
settings, changing the language resets them to
their default settings.
Note
•
This language setting is not effective for the
sub-display on the Feature Key screen, the
Calls screen (in Line Buttons mode), or the
Programming screen. To change the language
setting of the sub-display, see "PT
Programming (Page 134)".
•
For details about obtaining additional language
files, consult your dealer.

IP Address Settings

To properly connect the KX-NT400 to a network, the IP
address settings must be configured to match the
settings of the network. Consult your administrator for
details about the correct settings.
Note
•
IP Address Setting screen (1/2)
Enter the IP addresses that the KX-NT400 will use to
communicate over the network. If you use a DHCP
server, these addresses will be automatically obtained
from the DHCP server.
DHCP
Select whether to use a DHCP server to obtain the
IP addresses for the KX-NT400.
to select the
If you select Disable, you must enter the following
IP address settings manually.
•
VoIP IP Address
Enter the IP address for sending and receiving VoIP
data.
Application IP Address
Enter the IP address for sending and receiving other
IP data.
Subnet Mask
Enter the subnet mask for the network segment that
the KX-NT400 is connected to.
Default Gateway
Enter the IP address of the default gateway.
IP Address Setting screen (2/2)
Enter the IP address of the PBX or PBXs that the
KX-NT400 will communicate with.
The KX-NT400 requires 2 IP addresses.
Confirm that the 2 IP addresses are prepared
for it before configuring the IP Address settings.
Default: Enable
Installation and Setup
Operating Instructions 167