Modifying Radius Configuration Settings Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

Figure 56 shows sample output for the RADIUS method for the
/cfg/domain 1/aaa/auth <auth ID>
Authentication menu.
Figure 56
Authentication menu commands — RADIUS
>> Main# /cfg/domain 1/aaa/auth
Enter auth id: (1-63) 2
Creating Authentication 2
Select one of radius, ldap or local: radius
Auth name: radius
Entering: RADIUS settings menu
Entering: RADIUS servers menu
IP Address to add: <IPaddr>
Port (default is 1812):
Enter shared secret: <secret>
Leaving: RADIUS servers menu
Enter vendor id for group [alteon]:
Enter vendor type for group [1]:
Enter vendor id for domain [alteon]:
Enter vendor type for domain [3]:
Leaving: RADIUS settings menu
---------------------------------------------------------
[Authentication 2 Menu]
type - Set authentication mechanism
name - Set auth name
display - Set auth display name
radius - RADIUS settings menu
adv - Advanced settings menu
del - Remove Authentication
>> Authentication 2#

Modifying RADIUS configuration settings using the CLI

To modify settings for the authentication method itself, see
authentication methods using the CLI" on page
To modify settings for the specific RADIUS configuration, use the following
command:
/cfg/domain 1/aaa/auth #/radius
Chapter 6 Configuring authentication 245
command and commands on the
Nortel Secure Network Access Switch 4050 User Guide
"Configuring
239.