Mapping The Vlans - Nortel Secure Network Access Switch 4050 User Manual

800 Chapter 17 Configuration example
Adding the Ethernet Routing Switch 5510
Use the quick switch wizard:
>> Main# cfg/domain 1/quick
Enter the type of the switch (ERS8300/ERS5500) [ERS8300]:
ERS55
IP address of Switch: 10.200.200.20
NSNA communication port[5000]:
Trying to retrieve fingerprint...failed.
Error: "Failed to retrieve host key"
Do you want to add ssh key? (yes/no) [no]:
Red vlan id of Switch: 210
Creating Switch 2
Use apply to activate the new Switch.
>> Domain 1#
Export the Nortel SNAS 4050 public SSH key to a TFTP server, for manual
retrieval by the Ethernet Routing Switch 5500:
>> Main# cfg/domain 1/sshkey/export tftp 10.20.20.20
sac_key.1.pub
Import the public SSH key from the switch:
>> Main# cfg/domain 1/switch 2/sshkey/import

Mapping the VLANs

This example assumes that the VLANs defined on the Ethernet Routing
Switch 8300 (Switch 1) will always be used exclusively by Switch 1, whereas the
VLAN IDs for the VLANs defined on the Ethernet Routing Switch 5510
(Switch 2) may be used by other edge switches added to the domain in future.
Therefore, the VLAN mappings for Switch 1 are made at the switch-level
command, while the VLAN mappings for Switch 2 are made at the domain level.
>> Main# cfg/domain 1/switch 1/vlan/add yellow 120
>> Switch Vlan# add green 130
>> Switch Vlan# ../../vlan/add yellow 220
>> Domain Vlan# add green 230
320818-A