Configuring Session Timeout Using The Cli; Configuring Ldap Authentication Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

Configuring session timeout using the CLI

You can configure the Nortel SNAS 4050 to enable session timeout and to retrieve
a session timeout value from the RADIUS server. With session timeout enabled,
the session timeout value controls the length of the client's Nortel SNA network
session. When the time is up, the client is automatically logged out. Idle time has
no effect on the session timeout.
To configure the Nortel SNAS 4050 for session timeout, use the following
command:
/cfg/domain 1/aaa/auth #/radius/sessiontim
The Session Timeout menu displays.
The Session Timeout menu includes the following options:
/cfg/domain 1/aaa/auth #/radius/sessiontim
followed by:
vendorid <vendor ID>
vendortype <vendor
type>
ena
dis

Configuring LDAP authentication using the CLI

To configure the Nortel SNAS 4050 domain to use an external LDAP server for
authentication, use the following command:
/cfg/domain 1/aaa/auth <auth ID>
Chapter 6 Configuring authentication 249
Specifies the vendor-specific attribute used by the
RADIUS server to send a session timeout value to the
Nortel SNAS 4050. The default Vendor-Id is 0.
With the Vendor-Type also set to 0 (the default value),
the RADIUS server sends the standard attribute for
session timeout.
Specifies the Vendor-Type value used in combination
with the Vendor-Id to identify the session timeout value
to send to the Nortel SNAS 4050. The default is 0.
Enables retrieval of the RADIUS server session timeout
value. The default is disabled.
Disables retrieval of the RADIUS server session
timeout value. The default is disabled.
Nortel Secure Network Access Switch 4050 User Guide