Next Steps - Nortel Secure Network Access Switch 4050 User Manual

66 Chapter 2 Initial setup
12 Wait while the Setup utility finishes processing. When processing is complete,

Next steps

1
2
320818-A
you will see
Setup successful.
The new Nortel SNAS 4050 automatically picks up all other required
configuration data from the existing Nortel SNAS 4050 in the cluster. After a
short while, you receive the
Setup successful.
login:
To enable the SREM connection to the Nortel SNAS 4050:
a Use the
/cfg/sys/adm/ssh on
Nortel SNAS 4050 (for more information, see
administrative settings using the CLI" on page
b Use the
/cfg/sys/adm/srsadmin ena
TunnelGuard SRS administration (for more information, see
TunnelGuard SRS administration using the CLI" on page 485
"Configuring SRS control settings using the SREM" on page
Note: For greater security, you may want to restrict access to the Nortel
SNAS 4050 to those machines specified in an Access List. In this case,
ensure that you add an IP address for the SREM to the Access List. For
more information about using the Access List to control Telnet and SSH
access, see "Configuring the Access List using the CLI" on page 474
"Configuring the access list using the SREM" on page
From this point on, you can configure the Nortel SNAS 4050 using either the
CLI or the SREM.
To enable remote management using Telnet, use the
command to enable Telnet access to the Nortel SNAS 4050 (for
telnet on
more information, see
page 483).
prompt.
login
command to enable SSH access to the
"Configuring administrative settings using the CLI" on
"Configuring
483).
command to enable
"Enabling
or
547).
525.
/cfg/sys/adm/
or