Nortel Secure Network Access Switch 4050 User Manual page 81

The Switch menu includes the following options:
/cfg/domain #/switch <switch ID>
followed by:
name <name>
type ERS8300|ERS5500
ip <IPaddr>
port <port>
hlthchk
vlan
rvid <VLAN ID>
sshkey
reset
ena
Chapter 3 Managing the network access devices 81
Names or renames the switch. After you have defined a
name for the switch, you can use either the switch
name or the switch ID to access the Switch menu.
• is a string that must be unique in the domain.
name
The maximum length of the string is 255
characters.
Specifies the type of network access device. Valid
options are:
• — an Ethernet Routing Switch 8300
ERS8300
• — an Ethernet Routing Switch 5510,
ERS5500
5520, or 5530
The default is
ERS8300
Specifies the IP address of the switch.
Specifies the TCP port used for Nortel SNA
communication. The default is port 5000.
Accesses the Healthcheck menu, in order to configure
settings for the Nortel SNAS 4050 to monitor the health
of the switch (see
CLI" on page 89).
Accesses the Switch Vlan menu, in order to map the
Green and Yellow VLANs configured on switch (see
"Mapping the VLANs using the CLI" on page
Identifies the Red VLAN for the network access device.
• is the ID of the Red VLAN, as configured
VLAN ID
on the switch
Accesses the SSH Key menu, in order to manage the
exchange of public keys between the switch and the
Nortel SNAS 4050 (see
SNA communication using the CLI" on page
Resets all the Nortel SNA-enabled ports on the switch.
Clients connected to the ports are moved into the Red
VLAN.
Enables the network access device. As soon as you
enable the switch, the Nortel SNAS 4050 begins
communicating with the switch and controlling its Nortel
SNA clients.
Nortel Secure Network Access Switch 4050 User Guide
.
"Monitoring switch health using the
"Managing SSH keys for Nortel
82).
88)