Next Steps; Configuring Local Database Authentication Using The Srem - Nortel Secure Network Access Switch 4050 User Manual

298 Chapter 6 Configuring authentication
5

Next steps

1
2
3

Configuring local database authentication using the SREM

To configure the Nortel SNAS 4050 to use a local database for authentication,
perform the following steps:
1
2
3
4
320818-A
Click Apply on the toolbar to send the current changes to the Nortel
SNAS 4050. Click Commit on the toolbar to save the changes permanently.
Configure additional authentication methods, if desired (see
RADIUS authentication using the SREM" on page 271
database authentication using the SREM" on page
Set the authentication order (see
using the SREM" on page
Commit the changes (see
Note: If you ran the quick setup wizard during initial setup, Local
database authentication has been created with authentication ID = 1. The
database contains one test user (
tunnelguard. To continue configuring the local database, go to
"Populating the database" on page
Add the Local method to the domain and create the local database (see
"Adding the Local method" on page
Populate the database (see
Modify the local database settings, if desired (see
configuration" on page
Export the local database, if desired (see
page 312).
"Specifying authentication fallback order
314).
"Saving authentication settings" on page
), who belongs to a group called
tg
301.
299).
"Populating the database" on page
305).
"Exporting the database" on
"Configuring
or "Configuring local
298).
316).
301).
"Modifying Local database