Adding The Radius Authentication Method Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

You can perform the following configuration tasks:
• "Adding the RADIUS authentication method using the CLI" on page 243
• "Modifying RADIUS configuration settings using the CLI" on page 245
• "Managing RADIUS authentication servers using the CLI" on page 247
• "Configuring session timeout using the CLI" on page 249

Adding the RADIUS authentication method using the CLI

The command to create the authentication ID launches a wizard. When prompted,
enter the following information. You can later modify all settings for the specific
RADIUS configuration (see
on page 239 and "Modifying RADIUS configuration settings using the CLI" on
page 245).
• authentication type — options are
• authentication method name (
for the method. After you have defined a name for the method, you can use
either the method name or the
In future releases of the Nortel SNAS 4050 software, you will be able to
reference this string in a client filter, so that authentication to the server in
question becomes a condition for access rights for a group.
• IP address of the RADIUS server.
• port on which the RADIUS server is listening — the port number configured
on the RADIUS server to specify the port used by the service. The default is
1812.
• shared secret — a unique shared secret configured on the RADIUS server that
authenticates the Nortel SNAS 4050 to the RADIUS server.
• vendor ID for group — corresponds to the vendor-specific attribute used by
the RADIUS server to send group names to the Nortel SNAS 4050. The
default Vendor-Id is 1872 (Alteon).
To use a standard RADIUS attribute rather than the vendor-specific one, set
the vendor ID to 0 (see also vendor type).
Chapter 6 Configuring authentication 243
"Configuring authentication methods using the CLI"
radius|ldap|local
) — a string that specifies a name
auth name
to access the Authentication menu.
auth ID
Nortel Secure Network Access Switch 4050 User Guide
. Enter .
radius