Viewing Configuration Details Of Monitor Events - Nortel Secure Network Access Switch 4050 User Manual

2
Click Add.
The Add a Monitor dialog box appears. Depending on the type of monitor
selected, the fields displayed on the Add a Monitor dialog will differ slightly
(see Figure 189 on page
page 652).
3
Enter the Monitor information in the applicable fields.
Add a Monitor fields.
Table 137
Add a Monitor fields
Field
Monitor type
4
Click Apply.
The monitor event appears in the table.
5
Click Apply on the toolbar to send the current changes to the Nortel
SNAS 4050. Click Commit on the toolbar to save the changes permanently.

Viewing configuration details of monitor events

To view the configuration settings of an existing monitor event, perform the
following steps:
1 Select the System > Administrative > SNMP > Event > Monitor Table tab.
The Monitor Table appears (see
2 Select the monitor to view from the Monitor Table.
The Configuration sub-tab appears, displaying settings for the selected
monitor underneath the Monitor Table.
Monitor settings cannot be edited after the monitor is created. To change settings
for an existing monitor, that monitor must first be removed and then recreated
with the correct settings.
Chapter 12 Configuring SNMP 649
651, Figure 191 on page
Description
Specifies the type of monitor to add. The options are:
• Boolean
• Threshold
• Existence
Figure 188 on page
Nortel Secure Network Access Switch 4050 User Guide
654, and Figure 190 on
Table 137 describes the
648).