Nortel Secure Network Access Switch 4050 User Manual page 633

2
Enter the SNMP Configuration information in the applicable fields.
describes the SNMP Configuration fields.
Table 132
SNMP Configuration fields
Field
SONMP
System Contact
Authentication Traps
Enabled
SNMP Enabled
Versions
Read
Write
Trap
3 Click Apply on the toolbar to send the current changes to the Nortel
SNAS 4050. Click Commit on the toolbar to save the changes permanently.
Chapter 12 Configuring SNMP 633
Description
When checked, enables support for SynOptics Network
Management Protocol (SONMP) network topology
information. The default is disabled (unchecked).
Designates a contact person for the managed Nortel
SNAS 4050 cluster, together with information about how to
contact this person.
When checked, enables generating authentication failure
traps. The default is disabled (unchecked).
When checked, enables network management using
SNMP. The default is enabled.
Specifies the SNMP versions allowed. Check one or more
of the following options: v1 (SNMP version 1), v2c (SNMP
version 2c), v3 (SNMP version 3).
The default is all versions (v1, v2c, v3).
Specifies the monitor community name that grants read
access to the MIB. If you do not specify a monitor
community name, read access is not granted. The default
monitor community name is
Specifies the control community name that grants read and
write access to the MIB. If you do not specify a control
community name, neither read nor write access is granted.
Specifies the trap community name that accompanies trap
messages sent to the SNMP manager. If you do not specify
a trap community name, the sending of trap messages is
disabled. The default trap community name is
Nortel Secure Network Access Switch 4050 User Guide
Table 132
.
public
trap
.