Deleting A Network Access Device Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

Figure 4
Adding a switch manually
>> Domain 1# switch 1
Creating Switch 3
Enter name of the switch: Switch1_ERS8300
Enter the type of the switch (ERS8300/ERS5500): ERS8300
Enter IP address of the switch: <IPaddr>
NSNA communication port[5000]:
Enter VLAN Id of the Red VLAN: <VLAN ID>
Entering: SSH Key menu
Enter username: rwa
Leaving: SSH Key menu
----------------------------------------------------------
[Switch 3 Menu]
name
type
ip
port
hlthchk - Health check intervals for switch
vlan
rvid
sshkey
reset
ena
dis
delete
Error: Failed to retrieve host key
>> Switch 3#..

Deleting a network access device using the CLI

To remove a network access device from the domain configuration, first disable
the switch then delete it. Use the following commands:
/cfg/domain #/switch #/dis
/cfg/domain #/switch #/delete
The
disable
switch.
Chapter 3 Managing the network access devices 79
- Set Switch name
- Set Type of the switch
- Set IP address
- Set NSNA communication port
- Vlan menu
- Set Red VLAN Id
- SSH Key menu
- Reset all the ports on a switch
- Enable switch
- Disable switch
- Remove Switch
and commands log out all clients connected through the
delete
Nortel Secure Network Access Switch 4050 User Guide