Configuring Host Ports Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

472 Chapter 10 Configuring system settings
The system, host, or interface Routes menu displays.
When you add a static route to the system, host, or interface configuration, the
route is automatically assigned an index number. There are separate sequences of
index numbers for routes configured for the cluster, for each host, and for each
interface.
The system, host, or interface Routes menu includes the following options:
/cfg/sys/[host #[/interface #]/]routes
followed by:
list
del <index number>
add <IPaddr> <mask>
<gateway>

Configuring host ports using the CLI

To configure the connection properties for a port, use the following command:
/cfg/sys/host #/port <port>
where
physical port on the Nortel SNAS 4050. The port number is the number
identifying the port on the back of the Nortel SNAS 4050.
The Host Port menu displays.
320818-A
is an integer in the range 1 to 4 indicating the port number of the
port
Displays IP address information for all configured static
routes, by index number.
Removes the specified route from the system, host, or
interface configuration.
• is the identification number
index number
automatically assigned to the route when you
added the route to the configuration.
To view the index numbers of all configured static
routes, use the command.
list
Adds a static route to the system, host, or interface
configuration.
• is the destination IP address.
IPaddr
• is the network mask.
mask
• is the IP address on the core router.
gateway
An index number is automatically assigned to the route.