Setting Up The Ip Phone - Nortel Secure Network Access Switch 4050 User Manual

5
Configure VLAN Information:
a
In the Scope Options dialog box (see
191 VLAN Information.
b In the String value field, enter the following string:
VLAN-A:vvvv.
Table 211
Table 211
Parameter
A
vvvv
The site-specific option #191 pertains to the VLAN ID information that
the IP Phone will require in order to boot into the Phone VLAN.
The following rules apply:
— A colon (:) separates the hardware revision from the VLAN ID.
— The string must end in a period (.)
c Click Apply
6 Click OK.
7
Repeat step 1 on page 896
Phone VLAN.

Setting up the IP Phone

In order for the IP Phone to take advantage of the DHCP auto-configuration
features, set the IP Phone up as follows:
1 Set the DHCP Option on the IP Phone to
2 Select
0
3 Select
2
DHCP server.
Appendix F Configuring DHCP to auto-configure IP Phones 899
describes the parameters.
VLAN ID Information string parameter values
Description
The hardware revision of the IP Phone
The VLAN ID in decimal
through
to set the phone to use FULL DHCP.
(for ) to set the phone to learn its VLAN ID from the
Automatic
Nortel Secure Network Access Switch 4050 User Guide
Figure 248 on page
step 6 to configure the options for the
to use DHCP.
1
897), select