Applying And Saving The Configuration - Nortel Secure Network Access Switch 4050 User Manual

3
4

Applying and saving the configuration

On both the CLI and the SREM, you must enter explicit commands in order to
make configuration changes permanent and in order to create a backup
configuration file.
To finish connecting the Nortel SNAS 4050 to the rest of the network,
complete the following tasks:
a
Generate and activate the SSH keys for communication between the
Nortel SNAS 4050 and the network access devices (see
keys using the CLI" on page 84
SREM" on page
b Specify the SRS rule for the
groups using the CLI" on page 198
SREM" on page
c
Add the network access devices (see
using the CLI" on page 75
SREM" on page
d Specify the VLAN mappings (see
on page 82 or "Mapping the VLANs using the SREM" on page
e
If you did not run the quick setup wizard during the initial setup,
configure the following:
— Create the domain (see
page 121 or
— Create at least one group.
— Specify the VLANs to be used when the TunnelGuard check succeeds
and when it fails (see
on page 203
page 219).
Save the configuration (see
page 67).
or "Managing SSH keys using the
102).
tunnelguard
or
208).
or "Adding a network access device using the
91).
"Mapping the VLANs using the CLI"
"Creating a domain using the CLI" on
"Creating a domain using the SREM" on page
"Configuring extended profiles using the CLI"
or "Configuring extended profiles using the SREM" on
"Applying and saving the configuration" on
Nortel Secure Network Access Switch 4050 User Guide
Chapter 2 Initial setup 67
"Managing SSH
group (see "Configuring
"Configuring groups using the
"Adding a network access device
96).
151).