Nortel Sna Configuration And Management Tools - Nortel Secure Network Access Switch 4050 User Manual

42 Chapter 1 Overview
Figure 2
Figure 2
Two-armed configuration
Client portal interface (2)
192.168.128.11 (RIP 2 [host])
192.168.128.100 (pVIP [portal])

Nortel SNA configuration and management tools

You can use a number of device and network management tools to configure the
Nortel SNAS 4050 and manage the Nortel SNA solution:
•
320818-A
illustrates a two-armed configuration.
NSNAS
2
Internet
Endpoint
device
Command Line Interface (CLI)
You must use the CLI to perform initial setup on the Nortel SNAS 4050 and to
set up the Secure Shell (SSH) connection between the Nortel SNAS 4050 and
the network access devices, and between the Nortel SNAS 4050 and the GUI
management tool. You can then continue to use the CLI to configure and
manage the Nortel SNAS 4050, or you can use the GUI.
The configuration chapters in this User Guide describe the specific CLI
commands used to configure the Nortel SNAS 4050. For general information
about using the CLI, see
page 769.
Management interface (1)
1
10.1.0.11 (MIP [management])
10.1.0.12 (RIP 1 [host])
Default gateway
192.168.128.1
Network access device
Management
station
Chapter 16, "The Command Line Interface," on