Managing Network Access Devices Using The Cli; Roadmap Of Domain Commands - Nortel Secure Network Access Switch 4050 User Manual

You require the following information for each network access device:
•
•
•
•

Managing network access devices using the CLI

The Nortel SNAS 4050 starts communicating with the network access device as
soon as you enable the switch on the Nortel SNAS 4050 by using the
/cfg/domain #/switch #/ena
You cannot configure the VLAN mappings for a network access device in the
Nortel SNAS 4050 domain if the switch is enabled. When you add a network
access device to the domain, it is disabled by default. Do not enable the network
access device until you have completed the configuration. To reconfigure the
VLAN mappings for an existing network access device, first disable it by using
the
/cfg/domain #/switch #/dis

Roadmap of domain commands

The following roadmap lists the CLI commands to configure the network access
devices in a Nortel SNA deployment. Use this list as a quick reference or click on
any entry for more information:
Command
/cfg/domain #/switch <switch ID>
/cfg/domain #/switch #/delete
/cfg/domain #/switch <switch ID>
IP address of the switch
VLAN names and VLAN IDs for the Red, Yellow, and Green VLANs
the TCP port to be used for Nortel SNA communication
for Ethernet Routing Switch 8300 switches, a valid rwa user name
Chapter 3 Managing the network access devices 73
command.
command.
Parameter
name <name>
type ERS8300|ERS5500
ip <IPaddr>
port <port>
rvid <VLAN ID>
Nortel Secure Network Access Switch 4050 User Guide