Adding A Nortel Snas 4050 Device To A Cluster - Nortel Secure Network Access Switch 4050 User Manual

The profiles determine the VLAN to which the user will be allocated.
shows the extended profiles that have been created.
Table 2
Extended profile details
Index
1
2
6
One or several domain names have been added to the DNS search list,
depending on what you specified at the prompt in the quick setup wizard. This
means that the client can enter a short name in the portal's various address
fields (for example, inside instead of inside.example.com if
example.com was added to the search list).
7
If you selected the option to enable http to https redirection, an additional
server of the http type was created to redirect requests made with http to https,
since the Nortel SNAS 4050 portal requires an SSL connection.

Adding a Nortel SNAS 4050 device to a cluster

After you have installed the first Nortel SNAS 4050 in a cluster (see
single Nortel SNAS 4050 device or the first in a cluster" on page
another Nortel SNAS 4050 to the cluster by configuring the second Nortel
SNAS 4050 setup to use the same MIP. When you set up the Nortel SNAS 4050 to
join an existing cluster, the second Nortel SNAS 4050 gets most of its
configuration from the existing Nortel SNAS 4050 device in the cluster. The
amount of configuration you need to do at setup is minimal.
You can later modify settings for the cluster, the device, and the interfaces using
the
/cfg/sys/[host <host ID>/interface]
Client filter name
tg_failed
tg_passed
Nortel Secure Network Access Switch 4050 User Guide
Chapter 2 Initial setup 61
VLAN ID
yellow
green
commands.
Table 2
Linkset name
tg_failed
tg_passed
"Setting up a
52), you can add