Using The Quick Tunnelguard Setup Wizard In The Cli - Nortel Secure Network Access Switch 4050 User Manual

134 Chapter 4 Configuring the domain
/cfg/domain #/aaa/tg
followed by:
details on|off
loglevel
fatal|error|warning|
info|debug

Using the quick TunnelGuard setup wizard in the CLI

To configure the settings for the SRS rule check using the TunnelGuard quick
setup wizard, use the following command:
/cfg/domain #/aaa/tg/quick
The TunnelGuard quick setup wizard is similar to the last few steps of the Nortel
SNAS 4050 domain quick setup wizard. The wizard prompts you for the
following information:
•
•
320818-A
the action to be performed if the TunnelGuard check fails (see
page 127)
whether you want to create a test user (see
Specifies whether SRS failure details can be displayed
on the portal page.
Valid options are:
• — details will be displayed
on
• — details will not be displayed
off
The default is .
off
If set to , the client can click on the TG icon on the
on
portal page to display details about which elements of
the SRS rule check failed.
Sets the log level for debug information from the
TunnelGuard applet. The options are:
• — displays fatal errors only
fatal
• — displays all errors
error
• — displays warning information about
warning
conditions that are not error conditions
• — displays high-level information about
info
processes
• — displays detailed information about all
debug
processes
The default is .
info
The information displays in the client's Java Console
window. You can use the information to track errors in
the TunnelGuard SRS rules.
step 13 on page
step 12 on
127)