Configuring The Access List Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

474 Chapter 10 Configuring system settings
The Interface Ports menu includes the following options:
/cfg/sys/host #/interface <interface ID>/ports
followed by:
list
del <port>
add <port>

Configuring the Access List using the CLI

The Access List is a cluster-wide list of IP addresses for hosts authorized to access
the Nortel SNAS 4050 devices by Telnet, SSH, and SREM. You can configure the
list to allow access by individual machines or a range of machines on a specific
network.
If the Access List is empty, then access is open to any machine.
For information about enabling Telnet and SSH access, see
administrative settings using the CLI" on page 483
settings using the SREM" on page
To manage the Access List in order to control Telnet and SSH access to the Nortel
SNAS 4050 cluster, use the following command:
/cfg/sys/accesslist
320818-A
Note: Before you join a Nortel SNAS 4050 to the cluster, if there are
existing entries in the Access List, you must add to the Access List the
RIP (host IP address) for Interface 1 of all Nortel SNAS 4050 devices in
the cluster. You must do this before you perform the join. Otherwise, the
devices will not be able to communicate.
Displays all ports assigned to the interface.
Removes the specified port from the interface.
• is the port number of the physical port on the
port
device.
Adds a port to be used in the interface.
• is the port number of the physical port on the
port
device.
To view available port numbers on the Nortel
SNAS 4050 device, use the
/cfg/sys/host #/ports
page 467).
or
546.
command (see
"Configuring
"Configuring administrative