Configuring Linksets Using The Cli - Nortel Secure Network Access Switch 4050 User Manual

412 Chapter 9 Customizing the portal and user logon

Configuring linksets using the CLI

A linkset is a set of links that display on the portal Home tab. For more
information about linksets and links, see
To create and configure a linkset, use the following command:
/cfg/domain 1/linkset <linkset ID>
where
the linkset in the Nortel SNAS 4050 domain.
When you first create the linkset, if you do not specify the ID in the command,
you will be prompted to enter the linkset ID or name. You must enter the ID for
the new linkset. You will then be prompted to enter the linkset name. After you
have created the linkset, you can use either the ID or the name to access the linkset
for configuration.
The Linkset menu displays.
320818-A
is an integer in the range 1 to 1024 that uniquely identifies
linkset ID
Note: If you ran the quick setup wizard during initial setup, two linksets
have been created:
(linkset ID = 2). The linksets are empty.
"Linksets and links" on page
(linkset ID = 1) and
tg_passed
394.
tg_failed