Requirements; Procedure - Nortel Secure Network Access Switch 4050 User Manual

Requirements

To establish a console connection with the Nortel SNAS 4050, you need the
following:
• An ASCII terminal or a computer running terminal emulation software set to
the parameters shown in
Table 174
Console configuration parameters
Parameter
Baud rate
Data bits
Parity
Stop bits
Flow control
• A serial cable with a female DB-9 connector. For more specific information,
see the chapter about connecting to the Nortel SNAS 4050 in Nortel Secure
Network Access Switch 4050 Installation Guide (320846-A).

Procedure

1 Connect the terminal to the Console port using the correct serial cable.
When connecting to a Nortel SNAS 4050, use a serial cable with a female
DB-9 connector (shipped with the Nortel SNAS 4050).
2 Power on the terminal.
3 To establish the connection, press ENTER on your terminal.
You will next be required to log on by entering a user name and a password. For
more information on user accounts and default passwords, see
Nortel SNAS 4050 cluster" on page
Chapter 16 The Command Line Interface 771
Table 174:
Value
9600
8
None
1
None
775.
Nortel Secure Network Access Switch 4050 User Guide
"Accessing the