Print Condition - Konica Minolta DRYPRO Model 793 Operation Manual

Ch.4 Maintenance Mode
4-4-7 PRINT CONDITION <PRINT SETUP>
Allows to assign a default print condition to each diagnostic device for the case that the print condi-
tion is not designated by the diagnostic device.
Items that can be set in this default print condition are as follows.
Page Item
LUT SELECT
DENSITY
CONTRAST
1/3
SMOOTH
DENSITY MAX
DENSITY MIN
ILLUMINATION
2/3
AMBIENT LIGHT
FLIP
SORTER BIN
FILM ORIENTATION
3/3 POLARITY
BORDER
TRIM
Both "Luminance" and "Ambient Reflection" influence the image quality.
Therefore, do not manipulate these settings in normal operation.
DRYPRO Vstage MODEL 793 Operation Manual Ver.1.01 2005.1
Default
1 Select the LUT for the print condition.
Select from "1" - "7".
Use "LUT Setup" of the Maintenance Mode to set the details of LUT.
0 Sets the density of the image. Select from "-7" - "+7". More negative,
lighter the density, more plus, darker.
0 Sets the contrast (contrast between light and dark of the image) of the
image.Select from "-7" - "+7"
More negative, lower the contrast, more plus, higher.
2 Sets the smoothing of the image. Select from "0"~"7".
In the range of "0"~"6", larger the value, smoother the image.
However, too large in value makes the image blur.
Selecting "7" gives the same smoothing result as "0" is selected.
However magnification of the image is fixed at 100%.
Recommended is"2" or "3".
CH1, 2 : 300 Sets the max. density of the printed image. Set between "150" ~ "400".
Ch3 : 400 Higher the value, higher the max. density. Lower the value, lower the
CH4 - : 300 max. density.
20 Sets the min. density of the printed image. Set between "10" ~ "30".
Higher the value, higher the min. density. Lower the value, lower the
min. density.
2000 Sets the luminance of the light table. Normally, this value is specified
and sent from the diagnostic device.
Set between "0" ~ "38000".
10 Sets the ambient light. Normally, this value is specified and sent from
the diagnostic device.
Set between "0" ~ "38000".
OFF Selects whether to flip the print image. Select from OFF (not reversed)
or ON (reversed).
Selecting "ON(reversed)" will print the image laterally reversed.
1 Selects the bin to which the film is discharged when the sorter is in
use. Select from "1" ~ "6". Bin No.. is linked to that set by "Sorter
Setup (other settings)".
Portrait Sets the orientation of the film to be printed. Select from Portrait (long
edge to horizontal) or Landscape (long edge to vertical)
Pos Selects between Neg and Pos of printed film.
Black Selects the border color. Choices are black or transparent.
CH1, 2 : OFF Selects whether to print the trim. (ON/OFF)
CH3 : ON
CH4 - : OFF
< 68 >
Disp
Ope
Descriptions
User Level
1 2 3
● ● ●
●