Ch.7 Care & Maintenance; Periodic Maintenance And Inspection - Konica Minolta DRYPRO Model 793 Operation Manual

Ch.7 Care & Maintenance

7-1 Periodic Maintenance and Inspection

In order to ensure optimum performance from the DRYPRO 793, the following inspection and cleaning procedures
should be carried out regularly.
Outer Casing of Main Body
1) Film Ejection Tray
The film ejection tray is particularly prone to dust accumulation. Such dust can cause damage
to printed film.
Dust should be removed using a dry cloth or a vacuum cleaner.
2) Inlets/Outlets
Any dust on the outside of air inlets/outlets should be removed using a vacuum cleaner.
3) Supply Tray
Interior of Main Body
3) Supply Tray
The inside of the supply tray should be cleaned regularly.
Dust should be removed using a dry cloth or a vacuum cleaner.
4) Replacement of Deodorant Filter
10,000 prints or 6 months after the last filter replacement, the messages "FILTER
EXCHANGE" will appear on the Operation Panel.
The procedure for replacing the filter is described below.
When the [FILTER EXCHANGE] button and the error message are displayed at the same
time, always reset the error first.
Replacement of the Deodorant Filter while the error is present disables the recognition
of the Deodorant Filter Replacement.
1
DRYPRO Vstage MODEL 793 Operation Manual Ver.1.01 2005.1
1) Film Ejection Tray
2) Inlet
1
Touch the [FILTER EXCHANGE] button.
- An animation showing the Filter Exchange procedures will
be displayed on the Operation Panel.
< 142 >
2) Outlet
Animation of Deodorant
Filter Change 1-(1).