Film Loading - Konica Minolta DRYPRO Model 793 Operation Manual

Ch.3 Operation

3-4 Film Loading

When the supply tray becomes empty, a beep sound is released, followed by the [Film Set] button that is newly displayed in the
message column of the Operation Panel. (Beep sound can be selected from "Silent", "Single" and "Continuous" at the time of
installation) When this button is displayed, follow the procedures shown below to load the film package in the supply tray.
The DRYPRO 793 can receive the print data from the diagnostic device while it is in
film loading operation. The print data received during film loading will be printed after
the film loading is completed.
1
Sandwich Paper
One sheet of sandwich paper is always contained in a film package, and helps protect
the films from folding.
Do not put anything or lean on the Supply Tray while it is pulled out. Doing so will
damage the Supply Tray.
DRYPRO Vstage MODEL 793 Operation Manual Ver.1.01 2005.1
1
Touch the [Film Set] button.
- A message indicating that the tray is being pulled out.
- Supply tray pops out a few centimeters, and the animation
showing how to load the film package (pull out of the tray
~ removal of the sandwich paper and light-proof package)
will be displayed.
2
Gently and fully pull out the Supply Tray to its
end. (1 in the left fig.)
3
Fully open the Supply Shutter. (2 in the left fig.)
< 35 >
When a film is in print-
ing process, Supply
Tray cannot be pulled
out until that film has
been printed. This may
take maximum 95 sec.
Animation for "pull out
of the tray ~ removal of
the sandwich paper"
Shutter cannot be
opened if the Supply
Tray is not fully pulled
out.