Konica Minolta DRYPRO Model 793 Operation Manual page 22

Ch.2 Product Outline
2-1-3 Rear, Right Side, Top View
1) Film Exit Tray
2) Front Upper Cover
Release Lever
3) Right Cover
4) Power Breaker
5) Power Cable
Connector
6) Power Cable
1) Film Exit Tray
Printed films are output to this tray.
When an optional "6ch Sorter" is
installed, films are output to the sorter.
2) Front Upper Cover Release Lever
Releases the lock of the Front Upper
Cover when it is necessary to open.
3) Right Cover
When a film jam occurs in the Elevator
Transport unit, open this cover and take
the jammed film out.
4) Power Breaker
Turns ON/OFF the main power.
5) Power Cable Connector
Plug in the Power Cable.
Do not leave films equivalent to one package (= 125 sheets) or more on the Film Exit
Tray.
DRYPRO Vstage MODEL 793 Operation Manual Ver.1.01 2005.1
7) Outlet
8) Inlet
9) Ethernet Port
10) Serial Port
6) Power Cable
Connects the DRYPRO793 to the
power outlet of the facility.
7) Outlet (6 locations)
Air used to cool inside of the unit is
exhausted from this slot.
8) Inlet (2 on the right side, 1 on the rear
side)
Takes in the air to cool inside of the
unit.
9) Ethernet Port
Connects to the network.
10) Serial Port
When a backup battery is used, connect
the cable of the backup battery to this
port.
< 20 >
p.139 Film Jam in the Sorter
Transport Unit
p.136 Film Jam in the Elevator
Transport Unit