Setting Up The Monitor Display Modes - RADVision scopia xt5000 series Administrator's Manual

Setting up the Monitor Display Modes

About this task
You can configure the monitor from the XT Series endpoint or web interface by:
• Setting its resolution
• Configuring the system to work with a single monitor or two monitors side-by-side.
• Modify the default video layout to define whether the user sees two or three video streams on the
monitor(s): local video, remote video, and a data presentation.
For more information about video layouts, see Scopia XT Series User Guide.
Important:
If your monitor crops the edges of the image shown in their displays, adjust it as described in
Resolving Monitor Display Problems
Important:
You can return to the Default Auto settings at any time by pressing the Layouts
the XT Remote Control Unit.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the Scopia XT Series Locally from the Endpoint
Procedure
1. Access the monitor settings:
2. Configure the general monitor settings as follows:
Administrator Guide for Scopia XT5000 Series Version 3.2
on page 151.
• From the endpoint's main menu, select Configure > Advanced > I/O connections >
Monitor.
• From the XT Series web interface, select Administrator settings > I/O connections >
Monitor.
a. Select General to access the general settings.
key and then 0 on
on page 44.
Initial Configuration | 76