Setting Basic System Information; Remotely Setting The System Name And Language - RADVision scopia xt5000 series Administrator's Manual

3. Enter the IP address of the gatekeeper in the Gatekeeper IP address field.
4. Enter the H.323 number required to dial the XT Codec Unit in the E.164 field.
5. Select Done.

Setting Basic System Information

Set the system's basic information, such as the correct local time and date. We recommend modifying
the default administrator PIN to prevent users from modifying advanced settings. For more information,
see the following topics:
Navigation
•

Remotely Setting the System Name and Language

•
Setting Date and Time
•
Setting the Time Zone
•
Remotely Setting Regional Information
•
Configuring the Screen Saver to Start Automatically
Remotely Setting the System Name and Language
About this task
This procedure describes how to set the name and language of the endpoint from the web interface. You
can also do this as part of the quick setup from the endpoint itself, as described in
Name and Language
You can also configure the endpoint to use alternate system name, such as the SIP username, on both
the titlebar and on the monitors participating in the videoconference call, as described in
System's Name on the Titlebar
Procedure
1. Access the name and language settings:
Administrator Guide for Scopia XT5000 Series Version 3.2
Important:
If the gatekeeper is configured to be automatically detected by endpoints, select
Automatic (depends on the type of gatekeeper). Consult the network administrator.
The basic configuration of your Scopia XT Series is complete.
on page 66
on page 67
on page 56.
on page 63.
• From the XT Series web interface, select Basic Settings > Preferences > General.
• From the endpoint's main menu, select Configure > General.
on page 62
on page 68
on page 70
Setting the System
Modifying the
Initial Configuration | 62