Configuring The System For Snmp Management - RADVision scopia xt5000 series Administrator's Manual

2. Set the fields as required.
3. From the web interface only, select Save.
Administrator Guide for Scopia XT5000 Series Version 3.2
Figure 80: Configuring AT commands
Table 41: Configuring AT command settings
Field Name
AT commands
management
Enable all addresses
Address
Subnet mask
Description
Enable/disable AT command API for remote control, as follows:
• IP only: Select to enable the AT command API for
remote control.
• No: Select to disable the AT command API for remote
control.
Allow access to the XT Codec Unit from all or specific PCs, as
follows:
• Select Yes to enable access to Scopia XT Series from
any IP address in a network.
• Select No to allow access to specified computers only. If
selected, you must also configure the Address and
Subnet mask of each computer for which you want to
enable access.
This field is only relevant if you set the Enable all addresses
field as No.
Enter the IP address or IP addresses allowed to access the
system.
This field is only relevant if you set the Enable all addresses
field as No.
Enter the Subnet mask associated with the IP address.
Maintaining the Scopia XT Series | 135