Enabling At Commands For Managing The Xt Codec Unit - RADVision scopia xt5000 series Administrator's Manual

3. Define the time limit for point-to-point calls in the Call Time Limit field.

Enabling AT Commands for Managing the XT Codec Unit

About this task
Integration with Scopia Management allows you to manage the XT Codec Unit from a computer using
AT messages over a TCP/IP connection. The AT messages can be used for:
• Initialization
• Configuration of the system, including camera, monitor, and audio settings
• Moderating videoconferences
• Viewing system settings
• Diagnostics
The message exchange between the XT Codec Unit and the PC is based on ASCII characters.
Messages are sent over a TCP socket to port 55003 of the XT Codec Unit.
Before using this functionality, you must enable AT command management in the Scopia XT Series. Ask
customer support for information on how to use AT commands.
Before you begin
Ensure you have the IP addresses and the subnet mask of the computers which you want to use for
remote management of Scopia XT Series.
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the Scopia XT Series Locally from the Endpoint
Procedure
1. Access the AT settings, as follows:
Administrator Guide for Scopia XT5000 Series Version 3.2
By default, the time limit is Unlimited. The maximum limit you can set is 24 hours.
By default, the time limit is Unlimited. The maximum limit you can set is 24 hours.
• From the XT Series web interface, select Administrator Settings > Utilities > Remote
Access > AT Commands.
• From the endpoint's main menu, select Configure > Advanced > Utilities > Remote
Access > AT Commands.
on page 44.
Maintaining the Scopia XT Series | 134