Configuring Analog Audio Connections - RADVision scopia xt5000 series Administrator's Manual

3. Set the fields as described in
4. From the web interface only, select Save.

Configuring Analog Audio Connections

About this task
You must perform this procedure if you are using the analog audio connections:
Administrator Guide for Scopia XT5000 Series Version 3.2
Figure 43: Configuring the microphone settings from the web interface
82.
Table 21: Configuring the microphone connection
Field Name
Enabled Enables/disables the microphone.
Gain Use the slider to adjust the fixed Gain Control, setting the voice signal
to the desired level. The AGC reduces the volume if the audio is
strong and raises the volume if the audio is weak.
Echo canceller Enable the echo canceller when working with an external microphone
system that does not contain echo cancellation. If enabled check the
field settings in
configure if required.
Disable this setting when working with an external mixer that handles
echo cancellation.
Table 21: Configuring the microphone connection
Description
Configuring the Echo Canceller
on page
on page 84, and
Initial Configuration | 82