Elapsed Timeout For External-To-External Connection; Configuring A Timeout For An External-To-External Connection - Siemens HiPath 1100 Programming Manual

Programming an extension
Step by step
fel
q
fem
dddd.ehhd
92
Elapsed timeout for external-to-exter-
nal connection
It allows configuring a timeout between two external
calls when no other extension is involved in the call.
The user hears a warning tone before the timeout ex-
pires. The waring tone is sent 10 seconds before the
end of the timeout. When the call is between two ex-
ternal lines with no internal extension involved, the call
is terminated once the timeout elapses.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
r
or Activate/Disable the timeout:
q
= Activated
r
= Deactivated (default)
w
Initial status for programming mode.
Configuring a timeout for an external-
to-external connection
It allows configuring a timeout between two external
calls when no other extension is involved in the call. Call
timeout can be set from 1 minute to 24 hours (default
setting is 1 hour).
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
Enter a timeout for call connection (0000 to 1440, in 1-
minute increments).
w
Initial status for programming mode.