Relay - Siemens HiPath 1100 Programming Manual

Step by step
eki

Relay

The relay can be activated via the sensor, assuming that
the sensor is configured. It can be activated manually or
automatically after a specified time. When the relay is
activated, the contacts end. When it is deactivated, the
contacts open.
By default, the relay is set to Switch Mode.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
e i
Select the operating mode for the relay:
...
e
= "Switch": The relay can only be turned on from an
f
= "Monoflop": The relay is closed for a specified
g
= "Invert": The current status of the relay is reversed
h
= "Music on Hold": The relay can be used for
i
= "External signal": For an analog extension, a sec-
w
Initial status for programming mode.
Relay and sensor on the HiPath 1120
extension by entering the proper feature code
(see Miscellaneous functions - Relay in the User
Manual).
length of time. Alternatively, the relay can also be
opened before the set time, by entering the prop-
er feature code (see Miscellaneous functions -
Relay in the User Manual).
when the feature code to activate the Relay is
selected at an extension.
enabling external equipment connected for play-
ing announcements/music.
ond ring can be activated/deactivated using the
relay.
When playing music from an external music
source, all regulations related to copyrights for
the country in question must be followed.
183