Ending Remote Administration; Type Of Msn Signal - Siemens HiPath 1100 Programming Manual

Step by step
qmi
emj
dkg
To perform the required programming, proceed as if the
remote telephone were connected directly to the sys-
tem.
With a Fax/DID facility
If the system is equipped with a Fax/DID module pro-
grammed as an external line DID.
w
Enter the code using a remote MF telephone after the
call is answered.
w
p
The remote programmer must now enter the system
password using an MF telephone (default - 31994).
w
Wait for a confirmation tone to indicate that the pass-
word was accepted.
To perform the required programming, proceed as if the
remote telephone were connected directly to the sys-
tem.
If the system is connected through a serial cable
to a PC with access to the telephone system, the
programming can also be made using a modem
in conjunction with the HiPath 1100 Manager.
Refer to the instructions provided in the Help file.

Ending remote administration

Required: The remote telephone is in programming
mode.
w
Enter the programming code using the remote MF tele-
phone. This allows the system to free the external line
and the MF code receiver.
t
Replace the handset.

Type of MSN signal

This setting lets you choose one of the four types of
rings for various calls, and a ring for registered MSNs.
The default configuration for MSNs is Ring type 1.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
General settings
121