Programming Mode; Numbering Plan - Siemens HiPath 1100 Programming Manual

Step by step
Description
External line
Extension, including S
Groups of external lines
Call groups (CG)
Hunt groups (HG)
UCD subscriber groups
Carrier
EVM - Default internal number
EVM - Message ports
EVM - Virtual Ports

Programming mode

You can change the default settings of the HiPath 1100
to fit your needs. An MF-type or system telephone can
be used for this purpose, or a PC with the HiPath 1100
Manager
( page 186).
The instructions that follow refer to the factory
default settings.

Numbering plan

The Numbering plan is configured based on the mod-
ules detected by the system.
• For the HiPath 1120:
1. Motherboard
2. S module
0
3. Analog modules/UP
• For the HiPath 1150:
1. TME1 module;
2. Motherboard
3. S module
0
4. Analog modules/UP
• For the HiPath 1190:
1. TME1 module;
2. Analog modules/UP
3. S module
0
0
administration
Module
0/E
Module
0/E
Module
0/E
HiPath 1120 HiPath 1150 HiPath 1190
801 to 808 801 to 832
11 to 30 11 to 60
610 to 645
0 , 890 to 899
770 to 779
780 to 789
790 to 799
9
790
7491 and 7492
744 to 747
Programming mode
software installed
801 to 845
101 to 240
17