Operation As Satellite Pabx; External Line Connection; Second External Access Code - Siemens HiPath 1100 Programming Manual

External line settings
Step by step
egg
w
p
e
egh
50

Operation as Satellite PABX

External line connection.

This feature determines if an analog trunk connected to
one of the HiPath 1100 systems is also connected to a
local carrier or another PABX.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
. p
Enter the number for the group of external lines (e.g., 0,
890).
w
f
Enter the code for the type of connection:
or
e
= Conneection to Local carrier (default)
f
= Connection to another PABX system
w
r
Press this key.
Initial status for programming mode.

Second external access code

This setting specifies the code used by the main PABX
for accessing external lines. This code is used to check
if there is a dial tone at an external line and to generate
a pause while dialing, redialing or using the speed dial-
ing feature.
The default setting for the second code is "0".
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
When a group of external lines is configured as a
Satellite PBX, a false dial tone is not generated.
However, if LCR (code 225) or Emergency num-
bers (code 040) are programmed, the false dial-
ing tone will be generated.
When the line is programmed as connected to a
Local Carrier, the default flash time for this line is
240 ms and when configured as a Sub-PABX, the
default time is 100 ms.