Door Lock; Dids For Entrance Telephones - Siemens HiPath 1100 Programming Manual

Step by step
eej
e . fd
eim
e.fd
w
r
Press this key.
Initial status for programming mode.

Door lock

This feature detects when there is a locking device in-
stalled in a given slot in the internal entrance telephone.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
Enter the slot for the TFE Interface where the lock is lo-
cated (1 to 20).
q r
Activate/deactivate the door lock:
or
q
= Activated
r
= Deactivated (default)
w
p
Repeat these steps for any additional slot.
or
w
r
Press this key.
Initial status for programming mode.

DIDs for entrance telephones

It specifies the extensions that will be called during day
or night service when the entrance telephone is activat-
ed.
The default setting is extension 11/101.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
Enter the slot for the entrance telephone interface (1 to
20).
e f
Select a period of time:
or
1. By default, no slot is set as an entrance tele-
phone.
2. Each module of the TFE interface allows only
one entrance telephone to be connected.
3. Each TFE module works as an entrance tele-
phone OR pager interface. Two modules are
required to use both functions.
Entrance telephone
127