Alert Ring Timeout For Pickup Groups; Call Groups (Cg) - Siemens HiPath 1100 Programming Manual

Programming an extension
Step by step
ehg
de . ej
w
p
ehg
de . ej
dgi
dd . im
54
w
Enter the programming code.
w
Enter the number of the Pickup group (01 to 16).
w
. p
Configure extensions for a Pickup group (e.g., 11/101).
w
r
Press this key.
Initial status for programming mode.
Deleting Extensions from a Pickup group
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
Enter the number of the Pickup group (01 to 16).
w
q
Delete the extensions in the call Pickup group.
w
r
Press this key.
Initial status for programming mode.

Alert ring timeout for Pickup groups

If a call is not answered within a specified period of
time, a short alert ring is sent to the Pickup group (see
also Pickup groups).
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
Enter the length of time for the Alert Ring Signal (00 to
59 seconds).
or
w
q
Disable the alert ring signal (default).
w
Initial status for programming mode.

Call groups (CG)

Extensions can be grouped in Call groups (CG) that are
accessed by dialing a specific number ranging from 770
to 779. When the number is dialed all telephones in the
group ring until one of them is answered.
You can also add extensions to an existing Pickup
group.