Scans; Scan Types; Preparation - Icom ic-718 Instruction Manual

 Scan types
PROGRAMMED SCAN
Repeatedly scans between two scan edge frequencies
(scan edge memory channels P1 and P2).
Scan edge
P1 or P2
Scan
Jump
This scan operates in VFO mode.
  P reparation
• Channels
For programmed scan/auto memory write scan:
Enter scan edge frequencies into scan edge Memory
channels P1 and P2.
For a memory scan:-
Enter 2 or more Memory channels except scan edge
Memory channels.
• Scan resume ON/OFF
You can select the scan to resume or cancel when de-
tecting a signal, in the Set mode. Scan resume ON/
OFF must be set before operating a scan. See page
45 for ON/OFF setting and scan resume condition de-
tails.
• Scan speed
Scan speed can be selected from 2 levels, high or low,
in the Initial Set mode. See page 45 for details.
MEMORY SCAN
Repeatedly scans all programmed memory channels.
Scan edge
P2 or P1
Mch 1
This scan operates in the memory mode.
• Squelch condition
Scan
start
with
Squelch
open
Squelch
open
closed

SCANS

BLANK
Mch 2 Mch 3 Mch 4
BLANK
Mch 7 Mch 6
Mch 99
Programmed scan Memory scan
The scan continues Scan
until it is stopped man- each channel when
ually, and does not the scan resume is
pause even if it de- ON, not applicable
tects dignals. when OFF.
Scan stops when detecting a signal.
If you set scan resume ON in the Initial Set
mode, the scan paused for 10 seconds when
detecting a signal, then resumes. When a sig-
nal disappears whle scan is paused, scan re-
sumes 2 seconds later.
7
Mch 5
pauses on
39