D Band Stacking Register; Band Selection; D Programmable Tuning Steps - Icom ic-718 Instruction Manual

4
FREQUENCY SETTINGS

D Band Stacking Register

The Band Stacking Register automatically stores the
last used frequency and operating mode for each
band.
See the table below for a list of the bands available
and the default settings for each register.
BAND
1.9 MHz
3.5 MHz
7 MHz
10 MHz
14 MHz
General
D Band selection
All HF ham bands and a general coverage receiver
band are included in the IC-718.
➥ Push [UP ∫] or [√ DN] to select a desired band.
[UP ∫]
• Holding down
through the selectable bands.
NOTE: For example, if 6.10000 MHz is registered
as the General coverage frequency, the General
coverage band automatically positions itself be-
tween 3.5 MHz and 7 MHz band.

D Programmable tuning steps

Select the tuning step to suit your operating require-
ments.
• 0.1, 1, 5, 9, 10, 100 kHz are selectable
q Push [TS] to turn ON the Quick tuning function.
• "" appears.
w Hold down [TS] for 2 seconds to enter the Tuning
Step Set mode.
e Rotate [MAIN DIAL] to select a desired tuning
step.
• 0.1, 1, 5, 9, 10, or 100 kHz are selectable.
r Push [TS] to exit the mode.
t Rotate [MAIN DIAL] to change the frequency ac-
cording to the set tuning step.
y Push [TS] to turn OFF the Quick tuning function.
• "" disappears.
18
BAND BAND
1.91000 MHz CW
3.55000 MHz LSB
7.05000 MHz LSB
10.12000 MHz CW
14.10000 MHz USB
15.10000 MHz USB
or [√ DN] continuously scrolls
BAND BAND
18 MHz 18.10000 MHz
21 MHz 21.20000 MHz
24 MHz 24.95000 MHz
28 MHz 28.50000 MHz
29 MHz 29.50000 MHz
Z
DN
General (new)
BAND
USB
USB
USB
USB
USB
Y
UP
General (old)
Programmable tuning
step indicator
10 kHz tuning steps is
selected.