Icom ic-718 Instruction Manual page 8

2
PANEL DESCRIPTION
 Front panel
K
@2 VFO/MEMORY SWITCH/1 [V/M•1] (pp. 16, 35)
Push to toggle the operating mode between VFO
and Memory.
@3 MEMORY WRITE SWITCH/4 [MW•4] (p. 36)
Hold down for 1 second to enter the displayed fre-
quency and operating mode into the selected Mem-
ory channel.
@4 SPLIT SWITCH/7 [SPL•7] (p. 26)
Push to turn the Split Frequency function ON or
OFF.
@5 NR SWITCH/. [NR• . ] (p. 23)
➥ Push to turn the Noise Reduction function ON or
OFF. This function can be used in all modes.
• An optional UT-106 DSP UNIT is required.
• "NR" appears on the display.
➥ Hold down for 1 second to enter the Noise Re-
duction Level Set mode.
@6 ANF SWITCH/0 [ANF•0] (p. 23)
 P ush to turn the Automatic Notch Filter function ON
or OFF.
This function can be used in SSB and AM modes.
• An optional UT-106 DSP UNIT is required.
• "ANF" appears on the display.
@7 FREQUENCY INPUT/ENTER SWITCH
[F-INP/ENT]
➥ Push [F-INP/ENT] to enter the Direct Frequency
Input mode.
➥ After pushing [CH], push [F-INP/ENT] to enter
the Direct Memory Number Selection mode.
4
(continued)
1
A=B
V/M
MODE FILTER TS
4
MW M=CL
7
SPL
SCN
.
NR ANF
NB COMP
P.AMP ATT
Z
DN
CH
2 3
A/B
@2
1
V/M
5 6
M V
@3
4
MW
8 9
VOX
@4
7
SPL
F-INP
0
ENT
.
@5
NR
SET
TUNER
Y
UP
@8 SCAN SWITCH/8 [SCAN•8] (p. 39)
➥ Push to start or stop the Programmed Scan in
the VFO mode.
➥ Push to start or stop the Memory Scan in the
Memory mode.
@9 VOX SWITCH/9 [VOX•9] (p. 28)
In the SSB modes, push to turn the VOX function
ON or OFF.
#0 M≈V SWITCH/6 [MV•6] (p. 37)
Hold down for 1 second to copy the memory con-
tents to the VFO.
#1 MEMORY CLEAR SWITCH/5 [M=CL•5] (p. 38)
In the Memory mode, hold down for 1 second to
clear the selected Memory channel contents.
• "BLANK" appears above the Memory channel number.
#2 VFO SELECT SWITCH/3 [A/B•3] (p. 16)
➥ In the VFO mode, push to toggle between VFO
A and VFO B.
➥ When the Split Frequency function is ON, push
to toggle between the transmit and the receive
frequency.
#3 VFO EQUALIZATION SWITCH/2 [A=B•2]
Push to equalize the VFO B frequency and oper-
ating mode to the VFO A frequency and operating
mode.
#3 #2
2 3
A=B A/B #1
#0
5 6
M=CL M V
@9
8 9
SCN VOX
@8
F-INP
0
@7
ANF
ENT
@6